R&S FSV3000 Series - 13 Network and Remote Operation; Remote Control Basics; Remote Control Interfaces and Protocols

Network and Remote Operation
R&S
®
FSVA3000/ R&S
®
FSV3000
644User Manual 1178.8520.02 ─ 01
13 Network and Remote Operation
In addition to working with the R&S FSV/A interactively, located directly at the instru-
ment, it is also possible to operate and control it from a remote PC. Various methods
for remote control are supported:
●
Connecting the instrument to a (LAN) network
●
Using the LXI browser interface in a LAN network
●
Using the Windows Remote Desktop application in a LAN network
●
Connecting a PC via the GPIB interface
How to configure the remote control interfaces is described in Chapter 13.6, "How to
Set Up a Network and Remote Control", on page 710.
● Remote Control Basics......................................................................................... 644
● GPIB Languages...................................................................................................683
● The IECWIN Tool.................................................................................................. 685
● Automating Tasks with Remote Command Scripts............................................... 686
● Network and Remote Control Settings..................................................................696
● How to Set Up a Network and Remote Control.....................................................710
13.1 Remote Control Basics
Basic information on operating an instrument via remote control is provided here. This
information applies to all applications and operating modes on the R&S FSV/A.
For additional information on remote control of spectrum analyzers see the following
application notes available from the Rohde & Schwarz website:
1EF62: Hints and Tricks for Remote Control of Spectrum and Network Analyzers
1MA171: How to use Rohde & Schwarz Instruments in MATLAB
1MA208: Fast Remote Instrument Control with HiSLIP
● Remote Control Interfaces and Protocols............................................................. 644
● SCPI (Standard Commands for Programmable Instruments)...............................653
● VISA Libraries....................................................................................................... 654
● Messages..............................................................................................................654
● SCPI Command Structure.....................................................................................655
● Command Sequence and Synchronization...........................................................663
● Status Reporting System...................................................................................... 665
● General Programming Recommendations............................................................682
13.1.1 Remote Control Interfaces and Protocols
The instrument supports different interfaces and protocols for remote control. The fol-
lowing table gives an overview.
Remote Control Basics