R&S FSV3000 Series - Hardware Information; System Configuration Settings

General Instrument Setup
R&S
®
FSVA3000/ R&S
®
FSV3000
617User Manual 1178.8520.02 ─ 01
Resetting the Default Values
The values for the "Frequency" and "Loop Bandwidth" are stored for each source of
"Reference Frequency Input".
When you switch the input source, the previously defined settings are restored. You
can restore the default values for all input sources using the "Preset Channel" function.
12.8 System Configuration Settings
Access: [Setup] > "System Configuration"
● Hardware Information............................................................................................617
● Information on Versions and Options....................................................................618
● System Messages.................................................................................................619
● Firmware Updates.................................................................................................620
● General Configuration Settings.............................................................................622
● Signal Generator Settings.....................................................................................624
12.8.1 Hardware Information
Access: [Setup] > "System Configuration" > "Hardware Info"
An overview of the installed hardware in your R&S FSV/A is provided.
Every listed component is described by its serial number, order number, model infor-
mation, hardware code, and hardware revision.
This information can be useful when problems occur with the instrument and you
require support from Rohde & Schwarz.
Remote command:
DIAGnostic:SERVice:HWINfo? on page 1130
System Configuration Settings