R&S FSV3000 Series - Selecting the Mode and Applications; Selecting the Operating Mode and Application

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
736User Manual 1178.8520.02 ─ 01
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC).
Usage: Event
14.4 Selecting the Operating Mode and Application
The following commands are required to select the operating mode or the application
and to configure a Sequencer in a remote environment.
● Selecting the Mode and Applications....................................................................736
● Performing a Sequence of Measurements............................................................740
● Programming Example: Performing a Sequence of Measurements.....................742
14.4.1 Selecting the Mode and Applications
DISPlay:ATAB................................................................................................................736
INSTrument:CREate:DUPLicate...................................................................................... 736
INSTrument:CREate[:NEW]............................................................................................ 737
INSTrument:CREate:REPLace........................................................................................ 737
INSTrument:DELete....................................................................................................... 738
INSTrument:LIST?......................................................................................................... 738
INSTrument:REName.....................................................................................................739
INSTrument[:SELect]......................................................................................................739
DISPlay:ATAB <State>
This command switches between the MultiView tab and the most recently displayed
channel. If only one channel is active, this command has no effect.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
INSTrument:CREate:DUPLicate
This command duplicates the currently selected channel, i.e creates a new channel of
the same type and with the identical measurement settings. The name of the new
channel is the same as the copied channel, extended by a consecutive number (e.g.
"IQAnalyzer" -> "IQAnalyzer 2").
The channel to be duplicated must be selected first using the INST:SEL command.
Selecting the Operating Mode and Application