Applications, Measurement Channels
R&S
®
FSVA3000/ R&S
®
FSV3000
115User Manual 1178.8520.02 ─ 01
surement channel by double-tapping the name in the channel bar and entering a new
name.
For an overview of default names see INSTrument:LIST? on page 738.
Remote command:
INSTrument[:SELect] on page 739
New Channel ← Selecting an application
The applications selected on this tab are started in a new measurement channel, i.e. a
new tab in the display.
Remote command:
INSTrument:CREate[:NEW] on page 737
INSTrument[:SELect] on page 739
Replace Current Channel ← Selecting an application
The applications selected on this tab are started in the currently displayed measure-
ment channel, replacing the current application.
Remote command:
INSTrument:CREate:REPLace on page 737
Duplicate Current Channel ← Selecting an application
The currently active channel can be duplicated, i.e. a new channel of the same type
and with the identical measurement settings is started. The name of the new channel is
the same as the copied channel, extended by a consecutive number (e.g. "Spectrum" -
> "Spectrum 2" ).
Remote command:
INSTrument:CREate:DUPLicate on page 736
Closing an application
To close an application, simply close the corresponding tab by selecting the "x" next to
the channel name.
Remote command:
INSTrument:DELete on page 738
6.4 Running a Sequence of Measurements
Only one measurement can be performed at any time, namely the one in the currently
active channel. However, in order to perform the configured measurements consecu-
tively, a Sequencer function is provided.
● The Sequencer Concept....................................................................................... 116
● Sequencer Settings...............................................................................................118
● How to Set Up the Sequencer...............................................................................118
Running a Sequence of Measurements
To Next Page
Loading...
