R&S FSV3000 Series - Configuring Power Measurements

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
748User Manual 1178.8520.02 ─ 01
[SENSe:]SWEep:COUNt:CURRent?
This query returns the current number of started sweeps or measurements. This com-
mand is only available if a sweep count value is defined and the instrument is in single
sweep mode.
Return values:
<CurrentCount>
Example:
SWE:COUNt 64
Sets sweep count to 64
INIT:CONT OFF
Switches to single sweep mode
INIT
Starts a sweep (without waiting for the sweep end!)
SWE:COUN:CURR?
Queries the number of started sweeps
Usage: Query only
14.5.2 Configuring Power Measurements
The following commands work for several power measurements.
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:MODE...............................................748
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult?.............................................749
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:SELect.............................................. 750
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>[:STATe]..............................................750
[SENSe:]POWer:ACHannel:PRESet................................................................................ 751
[SENSe:]POWer:ACHannel:PRESet:RLEVel.....................................................................751
[SENSe:]POWer:TRACe.................................................................................................751
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:MODE <Mode>
This command selects the trace display mode for power measurements.
Suffix:
<n>
.
Window
<m> Marker
<sb> irrelevant
Parameters:
<Mode> WRITe | MAXHold
WRITe
The power is calculated from the current trace.
MAXHold
The power is calculated from the current trace and compared
with the previous power value using a maximum algorithm.
Manual operation: See " Power Mode " on page 162
Configuring and Performing Measurements