R&S FSV3000 Series - Page 747

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
747User Manual 1178.8520.02 ─ 01
ON | 1
Continuous sweep
OFF | 0
Single sweep
*RST: 1
<State> ON | OFF | 0 | 1
ON | 1
Continuous sweep
OFF | 0
Single sweep
*RST: 0
Example:
INIT:CONT OFF
Switches the sweep mode to single sweep.
INIT:CONT ON
Switches the sweep mode to continuous sweep.
Manual operation: See " Frequency Sweep " on page 122
See " Zero Span " on page 123
See " Continuous Sweep / Run Cont " on page 388
INITiate<n>[:IMMediate]
This command starts a (single) new measurement.
With sweep count or average count > 0, this means a restart of the corresponding
number of measurements. With trace mode MAXHold, MINHold and AVERage, the
previous results are reset on restarting the measurement.
You can synchronize to the end of the measurement with *OPC, *OPC? or *WAI.
For details on synchronization see Chapter 13.1.6, "Command Sequence and Syn-
chronization", on page 663.
Suffix:
<n>
.
irrelevant
Example:
INIT:CONT OFF
Switches to single sweep mode.
DISP:WIND:TRAC:MODE AVER
Switches on trace averaging.
SWE:COUN 20
Sets the sweep counter to 20 sweeps.
INIT;*WAI
Starts the measurement and waits for the end of the 20 sweeps.
Manual operation: See " Frequency Sweep " on page 122
See " Zero Span " on page 123
See " Single Sweep / Run Single " on page 387
Configuring and Performing Measurements