Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
741User Manual 1178.8520.02 ─ 01
Manual operation: See " Sequencer State " on page 118
INITiate:SEQuencer:IMMediate
This command starts a new sequence of measurements by the Sequencer.
Before this command can be executed, the Sequencer must be activated (see
SYSTem:SEQuencer on page 742).
Example:
SYST:SEQ ON
Activates the Sequencer.
INIT:SEQ:MODE SING
Sets single sequence mode so each active measurement will be
performed once.
INIT:SEQ:IMM
Starts the sequential measurements.
Manual operation: See " Sequencer State " on page 118
INITiate:SEQuencer:MODE <Mode>
This command selects the way the R&S FSV/A application performs measurements
sequentially.
Before this command can be executed, the Sequencer must be activated (see
SYSTem:SEQuencer on page 742).
A detailed programming example is provided in Chapter 14.4.3, "Programming Exam-
ple: Performing a Sequence of Measurements", on page 742.
Note: In order to synchronize to the end of a sequential measurement using *OPC,
*OPC? or *WAI you must use SINGle Sequence mode.
For details on synchronization see Chapter 13.1.6, "Command Sequence and Syn-
chronization", on page 663
Parameters:
<Mode> SINGle
Each measurement is performed once (regardless of the chan-
nel's sweep mode), considering each channels' sweep count,
until all measurements in all active channels have been per-
formed.
CONTinuous
The measurements in each active channel are performed one
after the other, repeatedly (regardless of the channel's sweep
mode), in the same order, until the Sequencer is stopped.
CDEFined
First, a single sequence is performed. Then, only those channels
in continuous sweep mode (INIT:CONT ON) are repeated.
*RST:
CONTinuous
Selecting the Operating Mode and Application
To Next Page
Loading...
