R&S FSV3000 Series - Page 636

General Instrument Setup
R&S
®
FSVA3000/ R&S
®
FSV3000
636User Manual 1178.8520.02 ─ 01
Info
Shows information for the selected coupling, for example, restrictions regarding the
coupling.
Note that usually, no information is displayed.
Remote command:
INSTrument:COUPle:USER<uc>:INFO on page 1145
Delete All
Deletes all current coupling definitions. Parameters are no longer coupled.
Remote command:
INSTrument:COUPle:USER<uc>:REMove on page 1149
Add New User Coupling
Opens a dialog box to create a new user-defined coupling definition.
Remote command:
INSTrument:COUPle:USER<uc>:NEW? on page 1146
Category ← Add New User Coupling
Selects the category of parameters to be displayed in the Coupling Element 1 / Cou-
pling Element 2 selection list.
Channel 1 / Channel 2 ← Add New User Coupling
Selects the channels for which the parameters are coupled. Only active channels are
available for selection. If no other active measurement channels have the selected
parameter, "Channel 2" is not available.
The following selections are possible:
●
Individual channels
●
All channels of the same type
Synchronizing Measurement Channel Configuration