R&S FSV3000 Series - Page 635

General Instrument Setup
R&S
®
FSVA3000/ R&S
®
FSV3000
635User Manual 1178.8520.02 ─ 01
Index
Index of the user-defined parameter coupling, used to identify the definition in remote
operation.
Remote command:
INSTrument:COUPle:USER<uc>:NUMBers:LIST? on page 1148
Edit coupling definition
Opens a dialog box to edit the selected coupling. See "Add New User Coupling"
on page 636.
Remote command:
INSTrument:COUPle:USER<uc> on page 1142
Parameter 1 / Parameter 2
The coupled parameters, markers, or lines.
Remote command:
INSTrument:COUPle:USER<uc>:NEW? on page 1146
State
Enables or disables the coupling.
Remote command:
INSTrument:COUPle:USER<uc>:STATe on page 1149
Direction
Determines which parameter controls the other.
"<-"
Parameter 2 controls parameter 1. If parameter 2 is changed, param-
eter 1 is adapted. If parameter 1 is changed, parameter 2 remains
unchanged.
Remote command:
INST:COUP:USER:REL RTOL
"->"
Parameter 1 controls parameter 2. If parameter 1 is changed, param-
eter 2 is adapted. If parameter 2 is changed, parameter 1 remains
unchanged.
Remote command:
INST:COUP:USER:REL LTOR
"<->"
Both parameters are equal. If one parameter is changed, the other
parameter is adapted and vice versa.
Remote command:
INST:COUP:USER:REL BID
Delete coupling definition
Deletes the selected coupling definition permanently.
Remote command:
INSTrument:COUPle:USER<uc>:REMove on page 1149
Synchronizing Measurement Channel Configuration