R&S FSV3000 Series - Page 1142

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1142User Manual 1178.8520.02 ─ 01
INSTrument:COUPle:VBW <State>
This command turns synchronization of the video bandwidth between measurement
channels on and off.
Parameters:
<State> ALL | NONE
ALL | 1
Turns on synchronization.
NONE | 0
Turns off synchronization.
*RST: NONE
Example:
INST:COUP:VBW ALL
Synchronizes the video bandwidth.
14.10.11.2
User-Defined Parameter Coupling
INSTrument:COUPle:USER<uc>................................................................................... 1142
INSTrument:COUPle:USER<uc>:CHANnel:LIST?........................................................... 1144
INSTrument:COUPle:USER<uc>:ELEMent:LIST?............................................................1144
INSTrument:COUPle:USER<uc>:INFO...........................................................................1145
INSTrument:COUPle:USER<uc>:NEW?......................................................................... 1146
INSTrument:COUPle:USER<uc>:NUMBers:LIST?...........................................................1148
INSTrument:COUPle:USER<uc>:RELation..................................................................... 1148
INSTrument:COUPle:USER<uc>:REMove......................................................................1149
INSTrument:COUPle:USER<uc>:STATe......................................................................... 1149
INSTrument:COUPle:USER<uc>:WINDow:LIST?............................................................ 1149
INSTrument:COUPle:USER<uc> <ChannelName>, <Window>, <Parameter>,
<ChannelName>, <Window>, <Parameter>, <arg6>, <State>
This command edits an existing user-defined coupling definition.
The parameters for this command are identical to INSTrument:COUPle:USER<uc>:
NEW?. Note, however, that for INSTrument:COUPling:USER<uc>, the last two
parameters (<Direction> and <State>) are not optional.
Note: Make sure to specify the right index number via the USER suffix.
Suffix:
<uc>
.
Index of a user-defined parameter coupling. Which indexes are
available is defined by INSTrument:COUPle:USER<uc>:
NUMBers:LIST?.
Parameters:
<ChannelName> String containing the name of a measurement channel or chan-
nel type.
<Name>
To synchronize two specific measurement channels.
'All Spectrum'
To synchronize all spectrum channels.
Configuring the R&S FSV/A