R&S FSV3000 Series - Page 1149

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1149User Manual 1178.8520.02 ─ 01
INSTrument:COUPle:USER<uc>:REMove [<Scope>]
This command deletes a user-defined coupling mechanism.
Suffix:
<uc>
.
Index of a user-defined parameter coupling. Which indexes are
available is defined by INSTrument:COUPle:USER<uc>:
NUMBers:LIST?.
Parameters:
<Scope> ALL
Optional SCPI parameter, used instead of the <uc> suffix.
Deletes all user-defined couplings.
Example:
INST:COUP:USER3:REM
Removes the user-defined coupling with the index number 3.
Manual operation: See "Delete coupling definition" on page 635
See "Delete All" on page 636
INSTrument:COUPle:USER<uc>:STATe <State>
Enables or disables the specified user-defined parameter coupling.
Suffix:
<uc>
.
Index of a user-defined parameter coupling. Which indexes are
available is defined by INSTrument:COUPle:USER<uc>:
NUMBers:LIST?.
Parameters:
<State> ON | OFF | 1 | 0
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST: 0
Example:
INST:COUP:USER2:STAT ON
Turns on the coupling with the index number 2.
Manual operation: See "State" on page 635
INSTrument:COUPle:USER<uc>:WINDow:LIST? [<ChannelName>, <Parameter>]
This command queries the measurement windows that can be synchronized with
another channel (or measurement window).
Note that synchronizing with a specific measurement window is only possible in the
Analog Demodulation application.
Suffix:
<uc>
.
irrelevant
Configuring the R&S FSV/A