Common Measurement Settings
R&S
®
FSVA3000/ R&S
®
FSV3000
306User Manual 1178.8520.02 ─ 01
1. "Select Measurement"
See Chapter 7, "Measurements and Results", on page 120
2. Input
See Chapter 8.2.2, "Input Source Settings", on page 311
3. Amplitude
See Chapter 8.4, "Amplitude and Vertical Axis Configuration", on page 366
4. Frequency
See Chapter 8.3, "Frequency and Span Configuration", on page 358
5. (Optionally:) Trigger/Gate
See Chapter 8.6, "Trigger and Gate Configuration", on page 391
6. Bandwidth
See Chapter 8.5.2, "Bandwidth, Filter and Sweep Settings", on page 382
(For SEM measurements: SEM Setup, see Chapter 7.6.5, "SEM Configuration",
on page 220)
(For Spurious measurements: Spurious Setup, see Chapter 7.7.4, "Spurious Emis-
sions Measurement Configuration", on page 255)
7. (Optionally:) Outputs
See Chapter 8.2.5, "Output Settings", on page 351
8. Analysis
See Chapter 9, "Common Analysis and Display Functions", on page 412
9. Display
See Chapter 9.1, "Result Display Configuration", on page 412
To configure settings
► Select any button to open the corresponding dialog box.
Select a setting in the channel bar (at the top of the channel tab) to change a spe-
cific setting.
Preset Channel
Select the "Preset Channel" button in the lower left-hand corner of the "Overview" to
restore all measurement settings in the current channel to their default values.
Do not confuse the "Preset Channel" button with the [Preset] key, which restores the
entire instrument to its default values and thus closes all channels on the R&S FSV/A
(except for the default channel)!
Remote command:
SYSTem:PRESet:CHANnel[:EXEC] on page 1074
Configuration Overview
To Next Page
Loading...
