R&S FSV3000 Series - Page 329

Common Measurement Settings
R&S
®
FSVA3000/ R&S
®
FSV3000
329User Manual 1178.8520.02 ─ 01
Generator
type
Model Driver file TTL sup-
port
Generator type Model Driver file TTL sup-
port
6 GHz SME06 X SMU 2 GHz SMU02 X
SMF100A 43.5 GHz SMF100A X 2 GHz
SMU02B31
2)
X
SMF 22 GHz SMF22 X 3 GHz
SMU03
2)
X
22 GHz SMF22B2 X 3 GHz
SMU03B31
2)
X
43 GHz SMF43 X 4 GHz
SMU04
2)
X
43 GHz SMF43B2 X 4 GHz
SMU04B31
2)
X
SMG all SMG - 6 GHz
SMU06
2)
X
SMGL all SMGL - 6 GHz
SMU06B31
2)
X
SMGU all SMGU - SMV 3 GHz SMV03 -
SMH all SMH - SMW 3 GHz SMW03
X
4)
SMHU SMHU - 6 GHz SMW06
X
4)
SMIQ 2 GHz SMIQ02 X 20 GHz SMW20
X
4)
2 GHz SMIQ02B X 40 GHz SMW40
X
4)
2 GHz SMIQ02E - SMX all SMX -
3 GHz SMIQ03 X SMY 1 GHz SMY01 -
3 GHz SMIQ03B X 2 GHz SMY02 -
3 GHz SMIQ03E -
4 GHz SMIQ04B X
6 GHz SMIQ06B X
1) Requires firmware version V2.10.x or higher on the signal generator
2) Requires firmware version V1.10.x or higher on the signal generator
3) Requires the option SMR-B11 on the signal generator
4) Requires firmware version V3.20.200 or higher on the signal generator
Generator Setup Files
For each signal generator type to be controlled by the R&S FSV/A a generator setup
file must be configured and stored on the R&S FSV/A. The setup file defines the fre-
quency and power ranges supported by the generator, as well as information required
for communication. For the signal generators listed in "Overview of Supported Genera-
tors" on page 328, default setup files are provided. If necessary, these files can be edi-
ted or duplicated for varying measurement setups or other instruments.
The existing setup files can be displayed in an editor in read-only mode directly from
the "External Generator" configuration dialog box. From there, they can be edited and
stored under a different name, and are then available on the R&S FSV/A.
(For details see "To define a new generator setup file" on page 345).
Data Input and Output