R&S FSV3000 Series - Page 726

Network and Remote Operation
R&S
®
FSVA3000/ R&S
®
FSV3000
726User Manual 1178.8520.02 ─ 01
Windows will then map drives of the controller to the corresponding network drives.
9. To use printers connected to the controller while accessing them from the
R&S FSV/A, activate the "Printers" option. Do not change the remaining settings.
10. Open the "Display" tab.
The options for configuring the R&S FSV/A screen display are displayed.
11. Under "Remote desktop size", you can set the size of the R&S FSV/A window on
the desktop of the controller.
12. Under "Colors", do not change the settings.
13. Set the "Display the connection bar when I use the full screen" option:
● If activated, a bar showing the network address of the R&S FSV/A will appear
at the top edge of the screen. You can use this bar to reduce, minimize or close
the window.
● If deactivated, the only way you can return to the controller desktop from the
R&S FSV/A screen in full screen mode is to select "Disconnect" from the
"Start" menu.
13.6.7.3 How to Start and Close the Remote Desktop
To set up a connection to the R&S FSV/A
1. In the "Remote Desktop Connection" dialog box (see Chapter 13.6.7.2, "How to
Configure the Controller", on page 724), open the "General" tab.
2. In the "Computer" field, enter the IP address of the R&S FSV/A.
In the "User name" field, enter instrument to log in as an administrator, or Normal
User to log in as a standard user.
In the "Password" field, enter 894129.
3. To save the connection configuration for later use:
a) Select the "Save As" button.
The "Save As" dialog box is displayed.
b) Enter the name for the connection information (*.RDP).
4. To load an existing connection configuration:
a) Select the "Open" button.
The "Open" dialog box is displayed.
b) Select the *.RDP file.
5. Select the "Connect" button.
The connection is set up.
6. If the "Disk drives" option is activated on the "Local Resources" tab, a warning is
displayed indicating that the drives are enabled for access from the R&S FSV/A.
Select "OK" to confirm the warning.
How to Set Up a Network and Remote Control