R&S FSV3000 Series - Page 819

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
819User Manual 1178.8520.02 ─ 01
Example:
//Select the band category 2
ESP2:MSR:BCAT BC2
//Set the base station class to medium range
ESP2:MSR:CLAS MED
//Set the maximum output power to 10 dBm.
ESP2:MSR:MPOW 10
//Set the base station RF bandwidth to 20 MHz
ESP2:MSR:RFBW 20MHZ
//GSM/Edge present
ESP2:MSR:GSM:CPR ON
//Power of the GSM carrier is 20dBm
ESP2:MSR:GSM:CARR 20
Manual operation:
See " Carrier Adjacent to RF Bandwidth Edge " on page 233
[SENSe:]ESPectrum<sb>:MSR:LTE:CPResent
<State>
This command defines whether an LTE FDD 1.4 MHz or 3 MHz carrier is located at the
edge of the specified RF bandwidth. In this case, the specification demands specific
limits for the SEM ranges.
This command is only available for band category 2 (see [SENSe:]ESPectrum<sb>:
MSR:BCATegory on page 816).
Suffix:
<sb>
.
1..n
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
//Select the band category 2
ESP2:MSR:BCAT BC2
//Set the base station class to medium range
ESP2:MSR:CLAS MED
//Set the maximum output power to 10 dBm.
ESP2:MSR:MPOW 10
//Set the base station RF bandwidth to 20 MHz
ESP2:MSR:RFBW 20MHZ
//LTE present
ESP2:MSR:LTE:CPR ON
//Calculate limits for MSR SEM
ESP2:MSR:APPL
Manual operation:
See " Carrier Adjacent to RF Bandwidth Edge " on page 233
[SENSe:]ESPectrum<sb>:MSR:MPOWer <Power>
Defines the maximum output power of the base station.
This setting is only available for base stations with a medium range base station class
(see [SENSe:]ESPectrum<sb>:MSR:CLASs on page 817).
Configuring and Performing Measurements