R&S FSV3000 Series - Page 851

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
851User Manual 1178.8520.02 ─ 01
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PPEak[:STATe] <State>
This command turns the evaluation to determine the positive peak time domain power
on and off.
The R&S FSV/A performs the measurement on the trace marker 1 is positioned on.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Manual operation: See " Results " on page 282
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:RMS[:STATe]
<State>
This command turns the evaluation to determine the RMS time domain power on and
off.
The R&S FSV/A performs the measurement on the trace marker 1 is positioned on.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Manual operation: See " Results " on page 282
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:SDEViation[:STATe] <State>
This command turns the evaluation to determine the standard deviation of the time
domain power on and off.
The R&S FSV/A performs the measurement on the trace marker 1 is positioned on.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
14.5.9.2 Performing a Time Domain Power Measurement
The following commands are required to perform a Time Domain Power measurement:
Configuring and Performing Measurements