R&S SMB100A User Manual

Instrument Function
R&S
®
SMB100A
106Operating Manual 1407.0806.32 ─ 21
Remote command:
:SYSTem:COMMunicate:NETWork[:COMMon]:WORKgroup on page 438
Address Mode
Selects the mode for assigning the IP address.
"Auto (DHCP)"
Assigns the IP address automatically, provided the network supports
DHCP (Dynamic Host Configuration Protocol)
The network used must support automatic assignment of the IP
address via DHCP or APIPA (Zeroconf) in order to use this function.
"Static"
Enables you to assign the IP address manually.
Remote command:
:SYSTem:COMMunicate:NETWork:IPADdress:MODE on page 439
IP Address
Displays the IP address.
By default, the R&S SMB is configured to use dynamic TCP/IP configuration and to
obtain the whole address information automatically.
If the network does not support DHCP or the attempt does not succeed, the instrument
tries to obtain the IP address via Zeroconf (APIPA) protocol. IP addresses assigned via
Zeroconf start with the number blocks 169.254.*.*.
Note: An IP address that is assigned via the Zeroconf protocol while the network
requires an IP address assigned via the DHCP server may cause network connection
failures.
See Chapter 9.5, "Resolving Network Connection Failures", on page 487.
To assign the IP address manually, select Address Mode "Static".
Remote command:
:SYSTem:COMMunicate:NETWork:IPADdress on page 439
Subnet Mask
Displays the bit group of the subnet in the host identifier.
To assign the subnet mask manually, select Address Mode "Static".
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:SUBNet:MASK on page 440
Default Gateway
Displays the gateway address.
To assign the gateway address manually, select Address Mode "Static".
This address identifies the router on the same network as the instrument that is used to
forward traffic to destinations beyond the local network.
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway on page 439
DNS Suffix
Displays the primary DNS (Domain Name System) suffix, that means the DNS name
without the host name part.
General Instrument Settings

R&S SMB100A Specifications

General

Brand	R&S
Model	SMB100A
Category	Inverter
Language	English