To Next Page

To Previous Page

Instrument Function

R&S

SMB100A

176Operating Manual 1407.0806.32 ─ 21

RF Frequency Sweep Settings

► To access the sweep dialog, select "RF > configure > Sweep/List > RF Frequency

Sweep".

In these dialogs you can configure the corresponding sweep signal.

State - Frequency Sweep

Activates RF sweep mode.

Note:

Activating a sweep mode automatically deactivates other sweeps and the list mode.

Remote command:

[:SOURce<hw>]:FREQuency:MODE on page 343

Mode - RF Frequency Sweep

Selects the RF frequency sweep mode.

If you change the sweep mode during the execution, the signal generator stops the

sweep and starts with the next trigger event at the initial value.

The "Reset Sweep" button sets the sweep to the start value.

"Auto"

Generates a continuously repeating sweep signal immediately after

activating the sweep mode.

The sweep steps are performed atomatically, controlled by the dwell

time, see "Dwell Time - Frequency Sweep" on page 181.

Example:

SOUR:SWE:FREQ:MODE AUTO

TRIG:FSW:SOUR AUTO

SOUR:FREQ:MODE SWE

"Single"

Generates a single sweep cycle after a trigger event.

The sweep steps within the cycle are performed automatically, con-

trolled by the dwell time. If one cycle is completed, the instrument

waits for the next trigger event.

To trigger the sweep, use "Execute Single Sweep" button, or the cor-

responding remote control commands, for example *TRG.

Example:

SOUR:SWE:FREQ:MODE AUTO

TRIG:FSW:SOUR SING

SOUR:FREQ:MODE SWE

SOUR:SWE:FREQ:EXEC

RF Block

R&S SMB100A User Manual

Other manuals for R&S SMB100A