Remote Control Basics
R&S
®
SMB100A
247Operating Manual 1407.0806.32 ─ 21
In this example, it is assumed that:
●
A LAN remote control link between the controller and the R&S SMB is already set
up.
●
The R&S VISA program is installed on the remote PC, see "http://www.rohde-
schwarz.com/rsvisa > RS VISA Release Notes".
Configuring the controller
To remote control the R&S SMB, we use the R&S VISA Tester application.
The instrument is preconfigured for networks using DHCP (dynamic host configuration
protocol). If this configuration is used, enter the computer name in the position of the IP
address.
To enable the external controller to communicate with the R&S SMB via TCP/IP proto-
col, set up a remote control link as follows:
1. Make sure that the controller and the instrument are connected in the network (net-
work cable) and switched on.
2. On the controller, start "R&S VISA > Tester 32bit" or "R&S VISA > Tester 64bit",
respectively.
3. In the menu bar, select "Choose VISA Implementation > Rohde & Schwarz Visa".
Starting a Remote Control Session
To Next Page
Loading...
Need help?
General