R&S SMB100A - Page 474

Remote Control Commands
R&S
®
SMB100A
459Operating Manual 1407.0806.32 ─ 21
STEReo:DIRect "ARI-ID=<Id>"
STEReo:DIRect? "ARI-ID"
(for documentation reasons only)
Selects the ARI identification.
Use SCPI command [:SOURce]:STEReo:ARI:TYPE instead.
Parameters:
<Id> 0 | 1 | 2 | 3
0
Off
1
DK (traffic announcement identification)
2
BK (area identification)
3
DK and BK (traffic announcement identification and area identifi-
cation)
Example:
STEReo:DIRect "ARI-ID=0"
Deactivates the ARI identification.
Example:
STEReo:DIRect? "ARI-ID"
Response: "0"
STEReo:DIRect "BIN=<x>"
Defines and sends, or queries, binary test patterns.The BIN command causes the
Stereo/RDS Coder to send periodic binary bit patterns instead of RDS data.
Parameters:
<x> 0
binary mode OFF
1
00000000...,
2
11111111...,
3
01010101...,
4
11001100...
Example:
STEReo:DIRect "BIN=2"
The binary test pattern is set to "2" so that only "1s" are transmit-
ted.
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5