Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
Table of Contents
CHAPTER 5 - USE OF THE SETUP MENU 13
5.1 - Networking 13
5.1.1 - Network Access Enabled 13
5.1.2 - Get IP Address 13
5.1.3 - IP Address 14
5.1.4 - Network Mask 14
5.1.5 - Default Router 14
5.1.6 - FTP AutoDelete 14
5.1.7 - SNMP Manager Setup 14
5.1.8 - SNMP Trap Setup 14
5.1.9 - SNMP Community Setup 15
5.1.10 - IP Address Restrictions 15
5.1.11 - Ping Router every 10 Mins 15
5.1.12 - PPP Dialout Setup 15
5.1.13 - PPP Hosting Setup 15
5.2 - Serial/Input Ports 15
5.3 - Passwords 16
5.4 - Event Definitions 16
5.4.1 - Set Up Sensor/Analog Events 16
5.4.2 - Upload New Alarm File 17
5.4.3 - View Alarm File 17
5.4.4 - Alarm Evaluator Enabled 18
5.4.5 - Store Data Record Events 18
5.4.6 - Store Alarm Record Events 18
5.4.7 - Store Sensor Events 18
5.4.8 - Store Reset Events 18
5.4.9 - Store Command Log Events 18
5.5 - Action Definitions 18
5.5.1 - Traps 19
5.5.2 - Pagers 19
5.6 - System Date/Time 20
5.7 - General Settings 20
5.7.1 - Set UnitID 20
5.7.2 - Operational Settings 21
5.7.3 - Character Mask 21
CHAPTER 6 - PASS THROUGH MODE 22
CHAPTER 7 - CONSOLE MODE 24
CHAPTER 8 - MANAGEMENT INFORMATION BASE (MIB) 25
CHAPTER 9 - SNMP CONFIGURATION AND CONTROL 29
CHAPTER 10 - USING FTP 40
To Next Page
Loading...