Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
Table of Contents
TABLE OF CONTENTS - SNMP ACCESS GATEWAY USER’S MANUAL
CHAPTER 1 - PRODUCT OVERVIEW 1
Figure 1. - SNMP Access Gateway Connectivity Overview 1
1.1 -- Introduction 1
1.2 -- IMUX 2000 Information 2
CHAPTER 2 - INSTALLATION 3
2.1 - Mounting 3
2.2 - Power Input 3
Figure 2. - SNMP Access Gateway Module and MA-810 Module Adapter 3
2.3 - Serial Ports 4
Figure 3. - SNMP Access Gateway DB9 Pin Out 4
2.4 - Ethernet 4
2.5 - Front Panel Items 5
Figure 5. - SNMP Access Gateway Front Panel Layout 5
CHAPTER 3 - BASIC SETUP FOR OPERATION 7
3.1 - Network Setup 7
3.2 - Local Command Mode 7
3.3 - Connections 8
CHAPTER 4 - COMMAND CONTROL 9
4.1 - Command Processor Mode 9
4.2 - General Commands 10
4.2.1 - EXIT 10
4.2.2 - BYE 10
4.2.3 -? (question mark) 10
4.2.4 - SETUP 10
4.2.5 - EVENTS 11
4.2.6 - DEFAULT 11
4.2.7 - COLDSTART 11
4.2.8 - HELP 11
4.2.9 - PING 11
4.3 - Pseudo-SNMP Commands 11
4.3.1 - GET 11
4.3.2 - GETNEXT 12
4.3.3 - GETX 12
4.3.4 - SET 12
4.3.5 - WALK 12
To Next Page
Loading...