Ricoh D147 - Page 1466

Main SP Tables-8
System Maintenance Section 2-747 D146/D147/D148/D149/D150
SP Mode Tables
003
Staple *CTL [0 to 9999999 / 0 / 1 / step]
Number of jobs started in Staple mode.
004
Booklet *CTL [0 to 9999999 / 0 / 1 / step]
Number of jobs started in Booklet mode. If the machine is in staple mode, the
Staple counter also increments.
005
Z-Fold *CTL [0 to 9999999 / 0 / 1 / step]
Number of jobs started In any mode other than the Booklet mode and set for
folding (Z-fold).
006
Punch *CTL [0 to 9999999 / 0 / 1 / step]
Number of jobs started in Punch mode. When Punch is set for a print job, the
P: counter increments. (See SP8-064-6.)
007
Other *CTL [0 to 9999999 / 0 / 1 / step]
(Reserved)
008 Inside-Flod *CTL [0 to 9999999 / 0 / 1 / step]
009 Three-In-Fold *CTL [0 to 9999999 / 0 / 1 / step]
010 Three-OUT-Fold *CTL [0 to 9999999 / 0 / 1 / step]
011 Four-Fold *CTL [0 to 9999999 / 0 / 1 / step]
012 KANNON-Fold *CTL [0 to 9999999 / 0 / 1 / step]
013 Perfect-Bind *CTL [0 to 9999999 / 0 / 1 / step]
014 Ring-Bind *CTL [0 to 9999999 / 0 / 1 / step]
8071
[T:Jobs/PGS]
These SPs count the number of jobs broken down by the number of pages in
the job, regardless of which application was used.
8072
[C:Jobs/PGS]
These SPs count and calculate the number of copy jobs by size based on the
number of pages in the job.
8073 [F:Jobs/PGS]