Ricoh D147 - Paper Transfer Exit Sensor; Tm (ID) Sensor; Before Replacing the TM(ID) Sensor

Image Transfer Unit
D146/D147/D148/D149/D150 4-76 SM
4.10.6 PAPER TRANSFER EXIT SENSOR
1. Open the right cover. (page 4-65 "Image Transfer Unit")
2. Fusing entrance sensor unit [A] ( ×1, ×1)
3. Fusing entrance sensor [A]
4.10.7 TM (ID) SENSOR
Before Replacing the TM(ID) sensor
Each sensor assembly has a list of characteristic values attached to it. Before you replacing the
TM / ID sensor, you must do the following procedure, or process control/MUSIC will not be done
correctly after power is switched on (it will use the values for the old sensor).
§ The characteristic values attached to the service part must be entered before
replacement. It is recommended that in case Process control/MUSIC after replacement is
not completed successfully, take a note of values of SP3-333,SP3-334,SP3-335.
1. Note the characteristic values that are listed on the bar code label.