SM 37 D163
Registering the Client-side Machine(s)
Up to six machines can be registered as the Client-side Machines.
On the Remote Machine:
1. Press the [User Tools/Counter] key on the operation panel
2. Press [System Settings] to select.
3. Press [Administrator Tools] to select.
4. Press [Program//Change/Delete Remote Machine] to select.
5. Enter the IP address or host name of the Client-side Machines.
6. Press [Set] to set after “connection test”.
Configuring the Remote Reception Settings
Do the following procedure to enable the Client-side Machine(s) to receive faxes via the Remote
Machine. You can forward or route received documents per line or special sender.
By performing procedures #1-3 above, the Client-side Machines can send faxes via the
Remote Machine. The procedures shown below are necessary to enable the Client-side
Machines to receive faxes.
On the Remote Machine:
1) If you use "Remote Reception Setting per Line"
1. Press [Facsimile Features] to select.
2. Press [Remote Reception Setting per Line] in [Reception Settings] to select.
3. Enter an IP address or a host name of the client-side machine to connect.
4. Press [Set], and [Exit] to exit from the setting.
2) If you use "Remote Reception per Sender"
1. Press [Facsimile Features] to select.
2. Press [Program Special Sender] in [Reception Settings] to select.
3. Select the Special Sender.
To Next Page
Loading...
