Printer SP Mode
System Maintenance Section 2-801 D146/D147/D148/D149/D150
If a paper size or type mismatch occurs during the printing of multiple
copies, only a single copy is output by default. Using this BitSw, the
device can be configured to print all copies even if a paper mismatch
occurs.
bit 2 Prevent SDK applications from altering
the contents of a job.
Disabled Enabled
If this BitSw is enabled, SDK applications will not be able to alter print
data. This is achieved by preventing SDK applications from accessing a
module called the "GPS Filter".
Note: The main purpose of this BitSw is for troubleshooting the effects of
SDK applications on data.
bit 3 [PS] PS Criteria Pattern3 Pattern1
Change the number of PS criterion used by the PS interpereter to
determine whether a job is PS data or not.
bit 4
Increase max. number of stored jobs.
Disabled
(100)
Enabled
(750)
Changes the maximum number of jobs that can be stored on the HDD.
The default (disabled) is 100. If this is enabled, the max. will be raised to
750 or 1000 depending on the model.
bit 5 DFU - -
bit 6
Method for determining the image rotation
for the edge to bind on.
Disabled Enabled
If enabled, the image rotation will be performed as they were in the
specifications of older models for the binding of pages of mixed
orientation jobs.
The old models are below:
- PCL: Pre-04A models
- PS/PDF/RPCS:Pre-05S models
bit 7
Letterhead mode printing Disabled
Enabled
(Duplex)
To Next Page
Loading...
