Printer SP Mode
System Maintenance Section 2-807 D146/D147/D148/D149/D150
SP Mode Tables
1001 [Bit Switch]
011 Bit Switch B 0 1
bit 0
Show Menu List Hide Menu
List
Show Menu
List
If this is 0, the Menu List button will be removed from Printer Features.
bit 1
Print job interruption Does not
allow
interruption
Allow
interruption
0 (default): Print jobs are not interrupted. If a job is promoted to the top of
the print queue, it will wait for the currently printing job to finish.
1: If a job is promoted to the top of the queue, it will interrupt the currently
printing job and start printing immediately.
bit 2 DFU - -
bit 3 Change the behavior of the center staple Cancel the
job
Continue to
print
This Bit Switch can change the behavior of the center staple when the maximum
number of sheets for stapling has been exceeded.
0 (default): The job is canceled and an error is recorded in the Error Log.
1: The job is not canceled and is produced. How the job is produced in any behavior
depends on the type of finisher.
NOTE: This Bit Switch applies only to jobs with center stapling. 12A controller–based
devices do not have a wa
to chan
e the behavior of
obs with ed
e or corner staplin
.
bit 4 DFU - -
bit 5 DFU - -
bit 6 DFU - -
bit 7 DFU - -
1001 [Bit Switch]
012 Bit Switch C 0 1
bit 0 DFU - -
bit 1 DFU - -
bit 2 DFU - -
bit 3 DFU - -
bit 4 DFU - -
bit 5 DFU - -
⇒
Rev. 8/12/2014
To Next Page
Loading...
