Output Check Table
D146/D147/D148/D149/D150 3-36 System Maintenance Section
5804
[OUTPUT Check]
Moves fusing motor. *See Important below
092
Fusing Motor:CW:Standard
Speed
ENG
[0 or 1 / 0 / 1/step]
093
Fusing Motor:CW:Middle
Speed
ENG
094 Fusing Motor:CW:Low Speed ENG
098
Fusing Motor:CCW:Low
Speed
ENG
Important: Use the procedure below to do the output checks for the fusing exit motor. If
you do not follow this procedure, a kink will form in the fusing belt sleeve, and the fusing
sleeve belt unit will need to be replaced.
1. Do one of the following:
§ Open the right cover of the paper bank
§ Remove one of the toner bottles
§ Pull out the waste toner bottle half-way
§ Remove the fusing unit
2. Enter SP mode.
3. Do the following out output checks:
§ SP5-804-092 (Fusing Motor:CW:Standard Speed)
§ SP5-804-093 (Fusing Motor:CW:Middle Speed)
§ SP5-804-094 (Fusing Motor:CW:Low Speed)
§ SP5-804-098 (Fusing Motor:CCW:Low Speed)
4. Without exiting SP mode, turn the main power switch off and then on again.
Important: If you exit SP mode before you turn the main power switch off, the fusing exit
motor will stay off when the machine warms up. Heat will be concentrated in one area of
the fusing belt sleeve and cause a kink to form. If this happens, you will need to replace
the fusing sleeve belt unit.
5. Do the reverse of what you did in step 1 (for example, reattach the fusing unit).
5804 [OUTPUT Check]
104
Polygon Motor: L ENG [0 or 1 / 0 / 1/step]
Runs motor with 21969 rpm.
To Next Page
Loading...
