Procedure
System Maintenance Section 5-5 D146/D147/D148/D149/D150
Firmware
D146/D147:
§ Check whether the card is properly in the SD card slot. When a SD card is inserted, a
click is heard, and it is locked.
§ To remove the card, release by pressing once in the set state.
5. Switch the power ON.
6. Wait until the update screen starts (about 45 seconds).
When it appears, "Please Wait" is displayed.
7. Check whether a program installation screen is displayed. (English display) When two or
more software modules are contained in the SD card, they are displayed as follows.
When two or more software names are displayed
1. Press the module selection button or 10 keypad [1] - [5].
2. Choose the appropriate module. (If already selected, cancel the selection)
Operation of keys or buttons
Keys or buttons to press Contents
[Exit] or 10 key [0] Returns to normal screen.
[Start] Key Select all modules.
[Clear/Stop] key Cancel all selection states.
To Next Page
Loading...
