SM 47 D163
The beeper sound is the same volume as the speaker sound.
The beeper sounds even if the sperker sound is turned off.
If the beeper does not sound, turn the main power switch on and off repeatedly and
do the transmission procedure 2 or 3 times.
If the beeper does not sound after turning the main switch on and off 3 times, you
need to input the settings stored in SRAM memory manually.
12. When “Ready” appears on the copy display, turn off the main power switch, and then
disconnect the flat cable from the removed FCU board.
13. Remove the removed FCU board (
x 1).
14. Remove the bracket from the center frame of the controller box (
x 1).
15. Disconnect the flat cable from the new FCU board.
16. Re-assemble the machine.
17. Turn on the main power switch, then do SP6-101 to print the system parameter list.
18. Check the system parameter list to make sure that the data is transferred correctly.
19. Set the correct date and time with the User Tools: User Tools > System Settings >
Timer Setting > Set Date/Time.
To Next Page
Loading...
