Ricoh D147 - Page 1826

D163 50 SM
Code Meaning Suggested Cause/Action
0-08 The other end sent RTN or
PIN after receiving a page,
because there were too many
errors
 Check the line connection.
 Replace the FCU.
 The other end may have jammed, or run
out of paper or memory space.
 Try adjusting the tx level and/or cable
equalizer settings.
 The other end may have a defective
modem/FCU; try sending to another
machine.
 Check for line problems and noise.
Cross reference
 Tx level - NCU Parameter 01 (PSTN)
 Cable equalizer - G3 Switch 07 (PSTN)
 Dedicated Tx parameters in Service
Program Mode
0-14 Non-standard post message
response code received
 Incompatible or defective remote terminal;
try sending to another machine.
 Noisy line: resend.
 Try adjusting the tx level and/or cable
equalizer settings.
 Replace the FCU.
Cross reference
See error code 0-08.
0-15 The other terminal is not
capable of specific functions.
The other terminal is not capable of accepting
the following functions, or the other terminal’s
memory is full.
 Confidential rx
 Transfer function
 SEP/SUB/PWD/SID