Ricoh D147 - Page 1828

D163 52 SM
Code Meaning Suggested Cause/Action
0-22 The signal from the other end
was interrupted for more than
the acceptable modem carrier
drop time (default: 200 ms)
 Check the line connection.
 Replace the FCU.
 Defective remote terminal.
 Check for line noise or other line problems.
 Try adjusting the acceptable modem
carrier drop time.
Cross reference
Acceptable modem carrier drop time - G3
Switch 0A, bits 0 and 1
0-23 Too many errors during
reception
 Check the line connection.
 Replace the FCU.
 Defective remote terminal
 Check for line noise or other line problems.
 Try asking the other end to adjust their tx
level.
 Try adjusting the rx cable equalizer setting
and/or rx error criteria.
Cross reference
Rx cable equalizer - G3 Switch 07 (PSTN)
Rx error criteria - Communication Switch 02,
bits 0 and 1
0-29 Data block format failure in
ECM reception
 Check for line noise or other line problems.
 Check the FCU - NCU connectors.
 Replace the NCU or FCU.
0-30 The other terminal did not
reply to NSS(A) in AI short
protocol mode
 Check the line connection.
 Try adjusting the tx level and/or cable
equalizer settings.
 The other terminal may not be compatible.
Cross reference
Dedicated tx parameters - Section 4
0-32 The other terminal sent a
DCS, which contained
functions that the receiving
machine cannot handle.
 Check the protocol dump list.
 Ask the other party to contact the
manufacturer.