Ricoh D147 - Page 1834

D163 58 SM
Code Meaning Suggested Cause/Action
6-09 G3 ECM - ERR received  Check for a noisy line.
 Adjust the tx levels of the communicating
machines.
 See code 6-05.
6-10 G3 ECM - error frames still
received at the other end after
all communication attempts at
2400 bps
 Check for line noise.
 Adjust the tx level (use NCU parameter 01
or the dedicated tx parameter for that
address).
 Check the line connection.
 Defective remote terminal.
6-21 V.21 flag detected during high
speed modem communication
 The other terminal may be defective or
incompatible.
6-22 The machine resets the
sequence because of an
abnormal handshake in the
V.34 control channel
 Check for line noise.
 If the same error occurs frequently, replace
the FCU.
 Defective remote terminal.
6-99 V.21 signal not stopped within
6 s
Replace the FCU.
13-17 SIP user name registration
error
 Double registration of the SIP user name.
 Capacity for user-name registration in the
SIP server is not sufficient.
13-18 SIP server access error  Incorrect initial setting for the SIP server.
 Defective SIP server.
13-24 SIP authentication error  Registered password in the device does
not match the password in the SIP server.
13-25 Network I/F setting error  IPV4 is not active in the active protocol
setting.
 IP address of the device is not registered.
13-26 Network I/F setting error at
power on
 Active protocol setting does not match the
I/F setting for SIP server.
 IP address of the device is not registered.
13-27 IP address setting error  IP address of the device is not registered.