Ricoh D147 - Page 1844

D163 68 SM
Code Meaning Suggested Cause/Action
15-95 Transfer Station Function  The machine rejected an incoming e-mail
for transfer because the transfer function
was unavailable.
16-00 No IP address registered  The machine does not get an IP address
because the DNS server has not been
registered for the remote machine or IP
address of the remote machine has not
been registered.
 Register the DNS server for the remote
machine or configure an IP address of the
remote machine.
22-00 Original length exceeded the
maximum scan length
 Divide the original into more than one
page.
 Check the resolution used for scanning.
Lower the scan resolution if possible.
 Add optional page memory.
22-01 Memory overflow while
receiving
 Wait for the files in the queue to be sent.
 Delete unnecessary files from memory.
 Transfer the substitute reception files to an
another fax machine, if the machine’s
printer is busy or out of order.
 Add an optional SAF memory card or hard
disk.
22-02 Tx or rx job stalled due to line
disconnection at the other end
 The job started normally but did not finish
normally; data may or may not have been
received fully.
 Restart the machine.
22-04 The machine cannot store
received data in the SAF
 Update the ROM
 Replace the FCU.
22-05 No G3 parameter confirmation
answer
 Defective FCU board or firmware.
23-00 Data read timeout during
construction
 Restart the machine.
 Replace the FCU.