Internal Finisher SR3130
SM 2-125 D146/D147/D148/D149/D150
13. Upper rear inner cover [A] ( ×1)
14. While pressing the bottom plate [A] into the area shown by the blue circle [B], insert it into the
slot shown by the blue circle [C][D] (
×3).
§ The following procedure is the easiest way to set this component.
§ 1) Slip the bottom plate [A] into the position in the blue circle [B].
§ 2) Insert the bottom plate [A] into the hole in the blue circle [C].
§ 3) When the bottom plate [A] is picked up (see below), it can be inserted into the hole
in the blue circle [D].
To Next Page
Loading...
