Self-Diagnostic Mode
SM 5-3 D146/D147/D148/D149/D150
When an automatic reboot is performed, a confirmation screen is displayed after reboot. The
confirmation screen can be cancelled by pressing the [OK] key (display is not cancelled only when
the main power switch is switched OFF to ON).
Screen display during reboot
§ Status display on the current screen
§ Post-processing ...... Post-processing during printing, etc.
§ Automatic reboot .... After operation end
Post-processing
Until automatic reboot
§ Reset key (Reboot key)
Key to perform reboot
# Cancel key is not displayed.
§ Turn on spanner LED (same as when an SC is generated).
Operation during SC reboot
§ Timing of SC reboot
When NRS is enabled, and when a NRS alarm*1 is not generated, the corresponding SC
is the object of an automatic reboot.
*1 NRS alarm: Issued when an ordinary SC (type D) is generated twice while the total counter
counts 10 times.
§ Time to automatic reboot
Reboot is performed 30 seconds after an engine reboot is possible, after the end of
post-processing during printing, etc.
At that time, a reboot is performed even if the MFP is operating. The engine does not
start process control when a reboot is possible.
§ Automatic reboot
See the flowchart below.
To Next Page
Loading...
