Service Call 501-584
SM 5-45 D146/D147/D148/D149/D150
SC No. Level Error Name/Error Condition/Major Cause/Solution
§ Lift motor error/connector missing
§ Limit sensor error/connector missing
§ Harness broken
§ Bank control board defective
§ Paper overload
§ Foreign matter, such as paper scrap, is caught between the
paper feed tray and the tray lift motor
§ Paper set fault
§ Reset the paper
§ Remove the foreign matter
§ Replace the motor
§ Reset the connector
§ Replace the harness
§ Replace the sensor
§ Replace the control board for the optional paper feed tray
§ Replace the tray
§ Replace the paper feed roller
§ Replace the pick-up arm
SC503-11 B 3rd Tray Lift Error (double bank, upper tray)
§ Lift motor ascent error detection
During tray initialization (upper limit not detected/lower limit
detection), the tray base plate is raised to check the tray
base plate position, and the limit sensor is not detected
although a predetermined time elapsed, for 3 times
consecutively.
(up to 2 times consecutively, the bank transmits a "tray set
fault" to the main machine)
§ Lift motor error/connector missing
§ Limit sensor error/connector missing
§ Harness broken
§ Bank control board defective
§ Foreign matter, such as paper scrap, is caught between the
paper feed tray and the tray lift motor
§ Paper set fault
To Next Page
Loading...
