Main SP Tables-1
D146/D147/D148/D149/D150 2-4 System Maintenance Section
1002
[Side-to-Side Registration]
Adjust image position against the transfer paper by adjusting start position for
writing. Reflects adjustment values with no change.
“+” is the direction to which images shift. (Trimming area in the left increases.)
“-“ is the direction to which images shift. (Trimming area in the left decreases.)
001 By-pass Tray ENG
[-4.0 to 4.0 / 0.0 / 0.1mm/step]
002 Paper Tray 1 ENG
003 Paper Tray 2 ENG
004 Paper Tray 3 ENG
005 Paper Tray 4 ENG
006 Duplex *ENG [-4.0 to 4.0 / 0.0 / 0.1mm/step]
007 Large Capacity Tray *ENG [-4.0 to 4.0 / 0.0 / 0.1mm/step]
1003 [Paper Buckle]
001 Paper Tray1: Thin *ENG [-4.0 to 5.0 / 0.0 / 0.1mm/step]
002 Paper Tray1: Plain *ENG [-4.0 to 5.0 / 0.0 / 0.1mm/step]
003 Paper Tray 1: Mid-thick *ENG [-4.0 to 5.0 / 0.0 / 0.1mm/step]
004 Paper Tray1: Thick1 *ENG [-4.0 to 5.0 / -2.0 / 0.1mm/step]
005 Tray2/3/4/5/LCT: Thin *ENG [-4.0 to 5.0 / 0.0 / 0.1mm/step]
006 Tray2/3/4/5/LCT: Plain *ENG [-4.0 to 5.0 / 0.0 / 0.1mm/step]
007 Tray 2/3/4/5/LCT: Mid-thick *ENG [-4.0 to 5.0 / 0.0 / 0.1mm/step]
008 Tray2/3/4/5/LCT: Thick 1 *ENG [-4.0 to 5.0 / -2.0 / 0.1mm/step]
009 By-pass: Thin *ENG [-4.0 to 5.0 / 0.0 / 0.1mm/step]
010 By-pass: Plain *ENG [-4.0 to 5.0 / 0.0 / 0.1mm/step]
011 By-pass: Mid-thick *ENG [-4.0 to 5.0 / 0.0 / 0.1mm/step]
012 By-pass:Thick1 *ENG [-4.0 to 5.0 / -1.0 / 0.1mm/step]
To Next Page
Loading...
