Ricoh MT-P2 - Page 309

ROM : 0.18.16
NEW : 0.18.6
• "ROM" is the version number of the module in the machine.
• "NEW" is the version number of the module on the SD card.
• If the "NEW" version number is higher than the "ROM" version number, the module requires
updating.
3. Push [Menu] to return to the previous level.
Engine
4. Push  to display the name of the next module, then push the [Menu] key again to review
the module name and version number.
5. Repeat this procedure to review the version numbers of the modules.
• If all the modules are current and do not require updating, press  until you see "Exit", then
press [#Enter]. The machine returns to standby mode. Remove the SD card from Slot 3. You do
not need to turn the machine power off/on.
How to Update a Module
Follow this procedure to update a module.
• More than one module can be selected for update.
1. Set the machine in the firmware update mode. (See "Setting the Machine in the Firmware
Update Mode" above.)
Engine
2. Push  or  to select the module that you want to update.
Engine
3. Push [#Enter]. An asterisk displays below the name of the module to indicate that it is selected
for update.
Engine
*
• Pushing [#Enter] and [Escape] alternately toggles the asterisk on and off.
5. Service Tables
308
5