4. After selecting the modules for updating, push to display "Update Data".
Update Data
*
5. Push [#Enter] to start the update of the selected modules.
Update Data
_ _ _ _ _ _ _ _ _ _ _ _
Asterisks replace the underscores in the progress line as the data updates.
Update Data
* * * _ _ _ _ _ _ _ _ _
• The "Update Data" display may repeat several times. Do not switch the machine off until the
message prompts you to turn the machine off. Updating all modules requires about 7 minutes.
When the update is completed, you will see:
Updated
Power Off On
6. Switch the machine off.
7. If you are finished, remove the SD card from the slot and turn the machine on.
Printing the Self-Diagnosis Report
The Self-Diagnosis Report, printed with SP5990 (SP Print Mode) lists the current names and version numbers
of the update modules.
1. To enter the SP mode, push and hold down for 5 sec. then push [#Enter].
2. Push to display "2. Engine" then push [#Enter].
3. Push to display "5. Mode" then push [#Enter].
SP5024
mm/inch Display
4. Push once to select SP5990 then push [#Enter].
SP5990-001
All (Data List)
Service Program Mode
309
To Next Page
Loading...
