112 Rockwell Automation Publication KNX-SG001H-EN-P - December 2020
Kinetix 5300 Single-axis EtherNet/IP Servo Drives
Kinetix 5300 Servo Drive Components
Kinetix 5300 servo drive systems consist of these required components:
•2198-Cxxxx-ERS servo drive
• Kinetix TLP servo motor
-Use 2090-CTFB-MxDD cable with (drive-end) connector
• Kinetix MPL, MPM, MPF, or MPS servo motor
-Use 2090-CPxM7DF power/brake cable with (drive-end) flying-leads
- Use 2090-CFBM7DD feedback cable with (drive-end) connector or 2090-CFBM7DF flying-lead feedback cables with
2198-K53CK-D15M feedback connector kit
• Kinetix TLY servo motor
-Use 2090-CPxM6DF power/brake cable with (drive-end) flying-leads
- Use 2090-CFBM6DD feedback cable with (drive-end) connector or 2090-CFBM6DF flying-lead feedback cables with
2198-K53CK-D15M feedback connector kit
• Kinetix MP linear actuators, LDAT-Series linear thrusters, and LDC/LDL-Series linear motors
-Use 2090-CPxM7DF power/brake cables and 2090-CFBM7DF feedback cables with the 2198-K53CK-D15M feedback connector kit
• Induction motor open-loop frequency control and closed-loop control of induction motor
• One 1606-XLxxx 24V power supply for control and motor brake power
• 1585J-M8CBJM-x (shielded) Ethernet cable
Kinetix 5300 servo drive systems can also include any of these optional components:
• One 2198-DBxxx-F AC line filter
• One 2097-Rx or 2198-Rxxx shunt resistor
• Bulletin 2198 (24V) shared-bus connector kits
For detailed Kinetix 5300 drive system requirements, refer to the Kinetix 5300 Drive Systems Design Guide, publication KNX-RM012
.
To Next Page
Loading...
Need help?
General
