Rohde & Schwarz RTB2004 - Page 436

Fernsteuerbefehle
R&S
®
RTB2000
436Bedienhandbuch 1333.1611.03 ─ 05
BUS<b>:UART:PARity <Parity>
Defines the optional parity bit that is used for error detection.
Suffix:
<b>
.
1..2
Selects the bus.
Note: SPI and UART protocols occupy two bus lines.
Parameter:
<Parity> ODD | EVEN | NONE
*RST: NONE
BUS<b>:UART:SBIT <StopBitNumber>
Sets the stop bits.
Suffix:
<b>
.
1..2
Selects the bus.
Note: SPI and UART protocols occupy two bus lines.
Parameter:
<StopBitNumber> B1 | B1_5 | B2
1 stop bit, 1.5 stop bits or 2 stop bits are possible.
*RST: B1
BUS<b>:UART:BAUDrate <Baudrate>
Sets the number of transmitted bits per second.
Suffix:
<b>
.
1 | 2
Parameter:
<Baudrate> Bereich: 100 bis 78.1E6
Inkrement: 100
*RST: 115200
Std.-einheit: Bit
BUS<b>:UART:BITime <BurstIdleTime>
Sets the minimal time between two data frames (packets), that is, between the last
stop bit and the start bit of the next frame.
Suffix:
<b>
.
1 | 2
Parameter:
<BurstIdleTime> Bereich: Range depends on the bus configuration, mainly on
bit rate and symbol size.
Std.-einheit: s
Analyse serieller Busse