Fernsteuerbefehle
R&S
®
RTB2000
276Bedienhandbuch 1333.1611.03 ─ 05
● Horizontale Einstellungen..................................................................................... 284
● Erfassungseinstellungen.......................................................................................286
● Messkurvendaten..................................................................................................291
15.4.1 Automatische Einstellungen
AUToscale
Performs an autoset process for analog channels: analyzes the enabled analog chan-
nel signals, and adjusts the horizontal, vertical, and trigger settings to display stable
waveforms
Verwendung:
Ereignis
Asynchroner Befehl
15.4.2
Erfassung starten und stoppen
RUN............................................................................................................................. 276
RUNContinous...............................................................................................................276
SINGle..........................................................................................................................276
RUNSingle.................................................................................................................... 276
ACQuire:NSINgle:COUNt................................................................................................276
STOP........................................................................................................................... 277
ACQuire:STATe..............................................................................................................277
RUN
RUNContinous
Starts the continuous acquisition.
Verwendung:
Ereignis
Asynchroner Befehl
SINGle
RUNSingle
Starts a defined number of acquisitions. The number of acquisitions is set with
ACQuire:NSINgle:COUNt.
Verwendung:
Ereignis
Asynchroner Befehl
ACQuire:NSINgle:COUNt <NSingleCount>
Sets the number of waveforms acquired with RUNSingle.
Grundeinstellungen
To Next Page
Loading...
