Rohde & Schwarz RTB2004 - Timeout-Trigger

Fernsteuerbefehle
R&S
®
RTB2000
301Bedienhandbuch 1333.1611.03 ─ 05
TRIGger:A:PATTern:WIDTh[:WIDTh] <PatternWidth>
For the ranges WITHin and OUTSide, the <PatternWidth> defines the center of a
range which is defined by the limits ±<Delta>.
For the ranges SHORter and LONGer, the pattern width defines the maximum and
minimum values, respectively.
Parameter:
<PatternWidth> Std.-einheit: s
TRIGger:A:PATTern:WIDTh:DELTa
<PatternDelta>
Defines a range around the pattern width value specified using TRIGger:A:
PATTern:WIDTh[:WIDTh].
Parameter:
<PatternDelta> Std.-einheit: s
15.5.6
Timeout-Trigger
Befehle zum Festlegen der Schaltschwelle (Schwellwert):
●
TRIGger:A:LEVel<n>[:VALue] auf Seite 294
CHANnel<m>:THReshold auf Seite 282
●
TRIGger:A:FINDlevel auf Seite 294
CHANnel<m>:THReshold:FINDlevel auf Seite 282
●
CHANnel<m>:THReshold:HYSTeresis auf Seite 282
TRIGger:A:TIMeout:RANGe............................................................................................301
TRIGger:A:TIMeout:TIME............................................................................................... 301
TRIGger:A:TIMeout:RANGe <Range>
Sets the relation of the signal level to the threshold.
Parameter:
<Range> HIGH | LOW | EITHer
HIGH
The signal level stays above the trigger level.
LOW
The signal level stays below the trigger level.
EITHer
The signal level stays above or below the trigger level.
*RST: HIGH
TRIGger:A:TIMeout:TIME <Time>
Sets the time limit for the timeout at which the instrument triggers.
Trigger