Sel SEL-787 - Page 404

B.2
SEL-787 Relay Instruction Manual Date Code 20150130
Firmware Upgrade Instructions
Upgrade Firmware Using ACSELERATOR QuickSet
Upgrade Firmware Using ACSELERATOR QuickSet
Select Tools > Firmware Loader
from the
ACSELERATOR QuickSet
menu bar to launch a wizard that
walks you through the steps to load
firmware into your SEL device.
Refer to Section 3: PC Software for
setup and connection procedures for
ACSELERATOR QuickSet.
Firmware Loader will not start if:
➤ The device is unsupported by
ACSELERATOR QuickSet.
➤ The device is not connected to the
computer with a communications
cable.
➤ The device is disabled.
Step 1. Prepare the device.
a. Select the firmware to be
loaded using the browse
control and select Save
calibration settings,
Save device settings,
and Save events report
files. Select Next to
continue the wizard.