sorin XTRA - Unpacking and Inspection; Storage and Transport Conditions; Electrical Requirements

Introduction and Safety
X
TRA Operator’s Manual 20077/021 US 1-15
Unpacking and Inspection
Prior to delivery, all components and modules of the XTRA have passed quality assurance testing.
Before each X
TRA system is considered to be operative, it should be checked by the user according to
the instructions given below.
Check on delivery that the unit outer container has not been damaged. If there are signs of
deterioration, a formal complaint must be made at once to the transport agents. Check the unit
carefully and ensure that there are no missing parts or visible signs of damage.
If any problems are noted, immediately communicate these with a detailed account of the problems
either to the local representative or directly to LivaNova, to the following address:
LivaNova Deutschland GmbH
Lindberghstrasse 25
D-80939 München Germany
Tel: +49.(0)89.32301.0
Fax: +49.(0)89.32301.555
Storage and Transport Conditions
Important: before storing or transporting, refer to “Storage and Transporting Warnings” starting on
page 1-9.
When still packed, the unit may be transported or stored under the following conditions:
• Temperature: -10°C (14°F) to +60°C (140°F)
• Humidity: 5% - 85%; RH non-condensing
• Atmospheric pressure: 80 - 106 kPa
Electrical Requirements
Warning: before using device, refer to “Electrical Warnings” starting on page 1-9.
The X
TRA must be connected to a fused and grounded wall socket in accordance with the regulations
in force in the country of use. Line voltage and current required must comply with what is indicated on
the identification labels and on the specification sheets in this manual. The length of the separator
power cord is 4m.