Installing the Disposables
X
TRA Operator’s Manual 20077/021 US 4-3
Step-by-step Procedures for Installing Disposables
Step 1: Installing the Blood Collection Reservoir
The setup of the Blood Collection Reservoir can be performed by inserting it into its holder on the rear
of the unit or by using the separate optional holder, to be fixed to an IV pole in the proximity of the
surgical field.
1. Swing open the reservoir holder and raise it to the desired height (see Figure 4-1).
Figure 4-1 Raising the Reservoir Holder
2. Remove the Blood Collection Reservoir from its package.
3. Keep the locking clip on the reservoir holder open, slide the edge of the reservoir lid into the slot
of the holder and push the reservoir into position. Release the locking clip (see Figure 4-2).
CAUTION
Use aseptic technique when installing disposables.
To Next Page
Loading...
