Spectra T200 - Enter Activation Keys

Chapter 4 — Configuring the Library Enabling BlueScale Software Support, Options, and Upgrades
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
103
Enter Activation Keys
Notes:  Paper copies of the activation keys for the initial BlueScale
Software Support license and the options you purchased
with the library are included with the library when shipped.
 The activation keys for the initial BlueScale Software Support
license and the options you purchased with the library are
entered during the installation of the library. Compare the
paper copies of the activation keys with information in the
Option Enablement pane of the System Setup screen and
enter any missing keys as described in this section.
 If you purchase options after the initial library installation,
you are provided an activation key for each option as
described in Add Options on page 104.
 If you receive activation keys by email, it is helpful to use the
BlueScale web interface (RLC) to access the System Setup
screen. You can then cut and paste keys from the email
containing the keys into the System Setup screen instead of
typing them.
Use the following steps to enter a new BlueScale Software Support key or
the activation key for a new option into the library.
1. Have on hand the activation key for the BlueScale Software Support
license or other option (see Obtain the Option Activation Key on
page 105).
2. Access the System Setup screen (see Accessing the System Setup Screen
on page 99).
The Option Enablement pane at the top of the screen lists the currently
licensed options.
3. Enter the activation key for the option you want to enable in the Key
field.
Note: The activation keys are not case-sensitive.
Figure 49 Enter the activation keys in the Option Enablement
pane of the System Setup screen.
Enter a new activation key