Chapter 5 — Operating the Library Monitoring Your Library
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
171
Use the BlueScale Vision Camera
The BlueScale Vision camera and web-based viewer application let you see the
interior of the library to observe import and export operations, tape mounts,
cartridge moves, and robotic operations in real time.
Use the following steps to launch the BlueScale Vision viewer.
1. Connect an Ethernet cable from the camera’s Ethernet port on the back
of the library to an Ethernet network.
2. Connect to the BlueScale Vision viewer using one of the following
methods.
Using the Camera Icon
a. Using a remote connection, log into the library’s BlueScale web
interface using a web browser.
Note: The software included with the black camera requires
ActiveX to view the streaming video and controls. You
must use Internet Explorer or see Streaming video and
camera controls do not work for the library camera on
page 349 for alternate solutions.
b. Select the camera icon on the status bar.
Note: The camera icon used to launch the BlueScale Vision
viewer is not present until you enter the IP address for the
camera in the System Configuration screen (see BlueScale
Vision IP Address on page 110).
Figure 96 Location of the camera Ethernet port.
Figure 97 The Status bar showing the Camera icon.
BlueScale Vision
camera connector
To Next Page
Loading...
