Spectra T200 - Calibrating the Touch Screen

Chapter 14 — Maintaining the Library Calibrating the Touch Screen
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
464
CALIBRATING THE TOUCH SCREEN
If the touch points on the library’s touch screen do not properly align with
the user interface graphics, perform the following procedure to recalibrate
the position of the touch points.
Note: You must perform this procedure while standing in front of the
touch screen. The utility is not available when accessing the
library through the BlueScale web interface (RLC).
1. Log into the library as a user with superuser or administrator privileges.
2. From the toolbar menu, select Maintenance > Tools to display the
Maintenance Tools screen (Figure 270 on page 443).
3. Select Utilities. The Utilities screen displays.
4. Select Calibrate Touch Screen.
5. Click Run Utility. The touch screen displays a series of calibration target
points.
6. Touch each point as it displays with either the stylus or your finger to
recalibrate the touch points on the screen.
Note: Touch each point at a straight-on angle as close to the center of
the target as possible.
7. When the calibration routine is complete, the Utilities screen
redisplays.